PLANET WGSW-52040 - Manual (Page 862)

63-402
63.19 show running-config current-mode
Command:
show running-config current-mode
Function:
Show the configuration under the current mode.
Command mode:
All configuration modes.
Default:
None.
Usage Guide:
Enter into any configuration mode and input this command under this mode, it can show all the configurations under
the current mode.
Example:
Switch(config-if-ethernet1/1)#show run c
!
Interface Ethernet1/1
switchport access vlan 2
!
63.20 show startup-config
Command:
show startup-config
Function:
Display the switch parameter configurations written into the Flash memory at the current operation; those are usually
also the configuration files used for the next power-up.
Default:
If the configuration parameters read from the Flash are the same as the default operating parameter, nothing will be
displayed.