PLANET WGSW-52040 - Manual (Page 806)

56-346
no sflow destination
Function:
Configure the IP address and port number of the host on which the sFlow analysis software is installed. If the port
has been configured with IP address, the port configuration will be applied, or else the global configuration will be
applied. The “no” form of this command restores the port to default and deletes the IP address.
Parameter:
is the IP address of the analyzer, shown in dotted decimal notation. <collector-port> is the
destination port of the sent sFlow packets.
Command Mode:
Global Mode and Port Mode.
Default:
The destination port of the sFlow packet is defaulted at 6343, and the analyzer has no default address.
Usage Guide:
If the analyzer address is configured at Port Mode, this IP address and port configured at Port Mode will be applied
when sending the sample packet. Or else the address and port configured at global mode will be applied. The
analyzer address should be configured to let the sFlow sample proxy work properly.
Example:
Configure the analyzer address and port at global mode.
switch (config)#sflow destination 192.168.1.200 1025
56.6 sflow header-len
Command:
sflow header-len
no sflow header-len
Function:
Configure the length of the head data packet copied in the sFlow data sampling. The “no” form of this command
restores the default value.
Parameter: