PLANET WGSW-52040 - Manual (Page 130)

3-129
Note：Routing protocols should be disabled on the layer-3 interface where cluster vlan locates to avoid broadcasting
private route of the cluster.
Example:
Disable cluster function in the local switch.
Switch (config)#no cluster run
3.11 cluster update member
Command:
cluster update member [ascii | binary]
Function:
Remotely upgrade member switches from the commander switch.
Parameters:
member-id：ranging from 1 to 128. Use hyphen “-” or semicolon “；” to specify more than one member;
src-url：the location of source files to be copied;
dst-filename：the specified filename for saving the file in the switch flash;
scii means that the file transmission follows ASCII standard; binary means that the file transmission follows binary
standard, which is de default mode.
when src-url is a FTP address, its form will be: ftp://:@/，in which
is the FTP username is the FTP password is the IP address of the FTP
server, is the name of the file to be downloaded via FTP.
when src-url is a TFTP address, its form will be: tftp:///，in which is the IP address of
the TFTP server is the name of the file to be downloaded via.
Special keywords used in filename:
Keywords source or destination address
startup-config start the configuration file
nos.img system file
Command mode:
Admin Mode
Usage Guide:
The commander distributes the remote upgrade command to members via the TCP connections between them,
causing the number to implement the remote upgrade and reboot. Trying to execute this command on a
non-commander switch will return errors. If users want to upgrade more than one member, these switches should be