PLANET WGSW-52040 - Manual (Page 801)

55-341
Parameters:
<session> is the session number of the mirror, which is currently support only one. <interface-number> is the
destination interface of the mirror.
Default:
None.
Command Mode:
Global mode
Usage Guide:
Four destination mirror interface are supported on the switch. To be mentioned. The interface which is configured as
the destination of the mirror should not be configured as the member of the interface trunk. And the maximum
throughput of the interface is recommended to be larger than the total throughput of the interfaces to be mirrored. If
the destination is removed, the mirror path configured will be removed at the same time. And if the destination
interface is reconfigured, the interface, CPU mirror path will be recovered. To be mentioned, the flow mirror can only
be recovered after the destination of the interface is re-configured.
Example:
Configure interface 1/7 as the destination of the mirror.
Switch(config)#monitor session 1 destination interface ethernet 1/7
55.4 show monitor
Command:
show monitor
Function:
To display information about the source and destination ports of all the mirror sessions.
Command Mode:
Admin Mode
Usage Guide:
This command is used to display the source and destination ports for the configured mirror sessions. For port
mirroring, CPU mirroring, and flow mirroring, the mirror mode of the source can be displayed.