PLANET WGSW-52040 - Manual (Page 471)

29-11
Switch(vlan-1-config)#ipv6 dhcp client pd hint 2001::/48
29.14 ipv6 dhcp pool
Command:
ipv6 dhcp pool
no ipv6 dhcp pool
Function:
To configure the address pool for DHCPv6, and enter the DHCPv6 address pool configuration mode. In this mode,
information such as the address prefix to be allocated, the DNS server addresses, and domain names, can be
configured for the DHCPv6 client. The no form of this command will remove the configuration of the address pool.
Parameter:
< poolname> is the address pool name of DHCPv6 with its length no more than 32.
Default:
Any DHCPv6 address pool are not configured by default.
Command Mode:
Global Mode.
Usage Guide:
This command should be launched in global configuration mode, and falls in DHCPv6 address pool configuration
mode if launched successfully. To remove a configured address pool, interface bindings related to the address pool,
as well as the related address bindings will be removed.
Example:
To define an address pool, named 1.
Switch(config)#ipv6 dhcp pool 1
29.15 ipv6 dhcp relay destination
Command:
ipv6 dhcp relay destination {[] [interface { <interface-name> | vlan <1-4096> } ] }