PLANET WGSW-52040 - Manual (Page 779)

53-319
Command mode:
ULPP group configuration mode.
Usage Guide:
None.
Example:
Configure the description of ULPP group as switch.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# description switch
53.8 flush disable arp
Command:
flush disable arp
Function:
Disable sending the flush packets of deleting ARP.
Parameter:
None.
Default:
By default, enable the sending function of the flush packets which are deleted by ARP.
Command mode:
ULPP group configuration mode.
Usage Guide:
If configure this command, when the link is switched, it will not actively send the flush packets to notify the upstream
device to delete the entries of ARP.
Example:
Disable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush disable arp