PLANET WGSW-52040 - Manual (Page 152)

4-151
4.1.14 shutdown
Command:
shutdown
no shutdown
Function:
Shuts down the specified Ethernet port; the no command opens the port.
Command mode:
Port Mode.
Default:
Ethernet port is open by default.
Usage Guide:
When Ethernet port is shut down, no data frames are sent in the port, and the port status displayed when the user
types the “show interface” command is “down”.
Example:
Opening ports 1/1-8.
Switch(config)#interface ethernet1/1-8
Switch(Config-If-Port-Range)#no shutdown
4.1.15 speed-duplex
Command:
speed-duplex {auto [10 [100 [1000]] [auto | full | half |]] | force10-half | force10-full | force100-half |
force100-full | force100-fx [module-type {auto-detected | no-phy-integrated | phy-integrated}] | {{force1g-half
| force1g-full} [nonegotiate [master | slave]]}| force10g-full}
no speed-duplex
Function:
Sets the speed and duplex mode for 1000Base-TX, 100Base-TX or 100Base-FX ports; the no command restores the
default speed and duplex mode setting, i.e., auto speed negotiation and duplex.