PLANET WGSW-52040 - Manual (Page 245)

14-14
After configuring this command, if the port is able to send LLDP-MED TLV, LLDP packets with LLDP-MED Inventory
Management TLVs sent by the port. However, LLDP packets without LLDP-MED Inventory Management TLVs sent
by the port after the switch configured the corresponding no command. Note: LLDP-MED Capability TLV sent by the
port must be configured before sending LLDP-MED Inventory Management TLVs, or else the configuration cannot
be successful.
Example:
Port 19 enables the function for sending LLDP-MED Inventory Management TLVs.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv inventory
14.10 lldp transmit med tlv networkPolicy
Command:
lldp transmit med tlv networkPolicy
no lldp transmit med tlv networkPolicy
Function:
Configure the specified port to send LLDP-MED Network Policy TLV. The no command disables the capability.
Parameter:
None.
Default:
The function is disabled for sending LLDP-MED Network Policy TLV.
Command Mode:
Port mode
Usage Guide:
After configuring this command, if the port is able to send LLDP-MED TLV, LLDP packets with LLDP-MED Network
Policy TLV sent by the port. However, LLDP packets without LLDP-MED Network Policy TLV sent by the port after
the switch configured the corresponding no command. Note: LLDP-MED Capability TLV sent by the port must be
configured before sending LLDP-MED Network Policy TLV, or else the configuration cannot be successful.
Example:
Port 19 enables the function for sending LLDP-MED Network Policy TLV.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv networkPolicy