PLANET WGSW-52040 - Manual (Page 510)

32-50
Global configuration mode
Usage Guide:
Configure this command if option 37 options is expected to be identified and processed by DHCPv6 server,
otherwise they will be ignored. Option 37 is not supported by default.
Example:
Enable the DHCPv6 server to support option 37.
Switch(Config)# ipv6 dhcp server remote-id option
32.1.10 ipv6 dhcp server select relay-forw
Command:
ipv6 dhcp server select relay-forw
no ipv6 dhcp server select relay-forw
Function:
This command enables the DHCPv6 server to support selections when multiple option 37 or option 38 options exist
and the option 37 and option 38 of relay-forw in the innermost layer are selected. The no operation of it restores the
default configuration, i.e. selecting option 37 and option 38 of the original packets.
Parameters:
None.
Default:
Selecting option 37 and option 38 of the original packets.
Command Mode:
Interface configuration mode
Usage Guide:
Make sure that the server has been enabled to support option 37 and option 38 before use this command. The
system selects option 37 and option 38 of the original packets by default.
Example:
Configure that the vlan1 interface of DHCPv6 server selects option 37 and option 38 of relay-forw in the innermost
layer.
Switch(Config-if-vlan1)# ipv6 dhcp server select relay-forw