PLANET WGSW-52040 - Manual (Page 814)

58-354
Chapter 58 Commands for
ERSPAN
58.1 monitor session
Command:
monitor session destination tunnel interface desmac < MAC address > desIP
< Dest IP address > scrIP < Source IP address
no monitor session destination tunnel interface
Function:
Appoint the mirror destination, and the destination can be the physical port or the tunnel; the no command deletes it.
Parameters:
is the value of session, it supports 1 to 4 currently;
is the mirror destination port;
is the MAC address of the equipment which is connected to the mirror destination port;
is the IP address of the tunnel that the tunnel destination is in;
is the IP address of the tunnel that this equipment is in.
Command Mode:
Global Mode.
Default:
None.
Usage Guide:
The switch supports 4 mirror destination. It should be noted that the destination only can be the physical port or the
tunnel; it should not be the members of the port aggregation and the port throughput should greater than or equal to
the sum of the throughput of all source ports which is monitored by it. Cancel the mirror destination of one session,
the port and CPU mirror access will restore. It should be noted that flow mirror can restore after configuring the
destination port and configuring it anew. If the mirror destination is tunnel, this tunnel must be GRE tunnel. This
tunnel can be no configuration, then users should configure the information of tunnel as GRE packet header.
Example:
Switch(config)#monitor session 1 destination interface Ethernet1/2 tunnel destination-mac 00-00-00-00-01-01
destination-IP 1.0.0.2 source-IP 1.1.1.1