PLANET WGSW-52040 - Manual (Page 672)

43-212
Chapter 43 Commands for
TACACS+
43.1 tacacs-server authentication host
Command:
tacacs-server authentication host <ip-address> [port <port-number>] [timeout ] [key {0 | 7}
] [primary]
no tacacs-server authentication host <ip-address>
Function:
Configure the IP address, listening port number, the value of timeout timer and the key string of the TACACS+ server;
the no form of this command deletes TACACS+ authentication server.
Parameter:
<ip-address> is the IP address of the server; <port-number> is the listening port number of the server, the valid
range is 0~65535, amongst 0 indicates it will not be an authentication server; is the value of TACACS+
authentication timeout timer, shown in seconds and the valid range is 1~60; is the key string, If key option is
set as 0, the key is not encrypted and its range should not exceed 64 characters, if key option is set as 7, the key is
encrypted and its range should not exceed 64 characters; primary indicates it’s a primary server.
Command Mode:
Global Mode
Default:
No TACACS+ authentication configured on the system by default.
Usage Guide:
This command is for specifying the IP address, port number, timeout timer value and the key string of the TACACS+
server used on authenticating with the switch. The parameter port is for define an authentication port number which
must be in accordance with the authentication port number of specified TACACS+ server which is 49 by default. The
parameters key and timeout is used to configure the self-key and self-timeout, if the switch is not configure the
timeout and key, it will use the global value and key by command tacacs-server
timeout and tacacs-server key . This command can configure several TACACS+ servers
communicate with the switch. The configuration sequence will be used as authentication server sequence. And in
case primary is configured on one TACACS+ server, the server will be the primary server.