PLANET WGSW-52040 - Manual (Page 486)

30-26
Chapter 30 Commands for DHCP
Option 82
30.1 debug ip dhcp relay packet
Command:
debug ip dhcp relay packet
Function:
This command is used to display the information of data packets processing in DHCP Relay Agent, including the
“add” and “peel” action of option 82.
Parameters:
None
Command Mode:
Admin Mode.
User Guide:
Use this command during the operation to display the procedure of data packets processing of the server and to
display the corresponding option82 operation information. Identified option 82 information of the request message
and the option 82 information returned by the reply message.
Example:
Display the information of data packets processing in DHCP Relay Agent.
Switch(config)# debug ip dhcp relay packet
30.2 ip dhcp relay information option
Command:
ip dhcp relay information option
no ip dhcp relay information option
Function:
Set this command to enable the option82 function of the switch Relay Agent. The “no ip dhcp relay information
option” command is used to disable the option82 function of the switch Relay Agent.