PLANET WGSW-52040 - Manual (Page 591)

36-131
Usage Guide:
It is recommended to use default value and if layer 3 MLD is in operation, please make this configuration in
accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query- robustness 3
36.1.15 ipv6 mld snooping vlan static-group
Command:
ipv6 mld snooping vlan static-group [source< X:X::X:X>] interface [ethernet |
port-channel]
no ipv6 mld snooping vlan static-group [source< X:X::X:X>] interface [ethernet |
port-channel]
Function:
Configure static-group on specified port of the VLAN. The no form of the command cancels this configuration.
Parameter:
vlan-id: ranging between <1-4094>
X:X::X:X:The address of group or source.
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode:
Global mode
Default:
No configuration by default.
Usage Guide:
When a group is a static while also a dynamic group, it should be taken as a static group. Deleting static group can
only be realized by the no form of the command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group ff1e::15 source 2000::1 interface ethernet 1/1