PLANET WGSW-52040 - Manual (Page 226)

12-225
12.2 show port-security
Command:
show port-security [interface <interface-id>] [address | vlan]
Function:
Show port-security configuration.
Parameter:
interface-id：Show port-security configuration of the interface.
address: Show the secure address of the interface.
vlan: Show the maximum number of each VLAN configured on trunk/hybrid interface.
Default:
None.
Command Mode:
Any modes
Usage Guide:
None.
Example:
Show all secure MACs on the interfaces.
Switch# show port-security address interface ethernet 1/1
12.3 switchport port-security
Command:
switchport port-security
no switchport port-security
Function:
Configure port-security function for the interface, the no command disables port-security.
Parameter:
None.
Default: