PLANET WGSW-52040 - Manual (Page 684)

44-224
Usage guide:
The source IPv6 address must belongs to one of the IPv6 interface of the switch, otherwise a failure message of
binding IPv6 address will be returned when the switch send RADIUS packet. We suggest using the IPv6 address of
loopback interface as source IPv6 address, it avoids that the packets from RADIUS server are dropped when the
interface link-down.
Example:
Configure the source ipv6 address of RADIUS packet as 2001:da8:456::1.
Switch#radius nas-ipv6 2001:da8:456::1
44.11 radius-server accounting host
Command:
radius-server accounting host {<ipv4-address> | <ipv6-address>} [port >] [key {0 | 7} <string>]
[primary]
no radius-server accounting host {<ipv4-address> | <ipv6-address>}
Function:
Specifies the IPv4/IPv6 address and the port number, whether be primary server for RADIUS accounting server; the
no command deletes the RADIUS accounting server.
Parameters:
| > stands for the server IPv4/IPv6 address;
for server listening port number from 0 to 65535;
<string> is the key string. If key option is set as 0, the key is not encrypted and its range should not exceed 64
characters, if key option is set as 7, the key is encrypted and its range should not exceed 64 characters;
primary for primary server. Multiple RADIUS sever can be configured and would be available. RADIUS server will
be searched by the configured order if primary is not configured, otherwise, the specified RADIUS server will be
used first.
Command Mode:
Global Mode
Default:
No RADIUS accounting server is configured by default.