PLANET WGSW-52040 - Manual (Page 402)

23-13
23.2.13 ipv6 nd dad attempts
Command:
ipv6 nd dad attempts
no ipv6 nd dad attempts
Function:
Set Neighbor Solicitation Message number sent in succession by interface when setting Duplicate Address
Detection.
Parameter:
<value> is the Neighbor Solicitation Message number sent in succession by Duplicate Address Detection, and the
value of <value> must be in 0-10, NO command restores to default value 1.
Command Mode:
Interface Configuration Mode
Default:
The default request message number is 1.
Usage Guide:
When configuring an IPv6 address, it is required to process IPv6 Duplicate Address Detection, this command is used
to configure the ND message number of Duplicate Address Detection to be sent, value being 0 means no Duplicate
Address Detection is executed.
Example:
The Neighbor Solicitation Message number sent in succession by interface when setting Duplicate Address
Detection is 3.
Switch(Config-if-Vlan1)# ipv6 nd dad attempts 3
23.2.14 ipv6 nd ns-interval
Command:
ipv6 nd ns-interval
no ipv6 nd ns-interval
Function: