PLANET WGSW-52040 - Manual (Page 244)

14-13
Command Mode:
Port mode
Usage Guide:
After configuring this command, if the port is able to send LLDP-MED TLV, LLDP packets with LLDP-MED Extended
Power-Via-MDI TLV sent by the port. However, LLDP packets without LLDP-MED Extended Power-Via-MDI TLV
sent by the port after the switch configured the corresponding no command. Note: LLDP-MED Capability TLV sent
by the port must be configured before sending LLDP-MED Extended Power-Via-MDI TLV, or else the configuration
cannot be successful. If the device does not support PoE or PoE function of the port is disabled, although configuring
this command, LLDP-MED Extended Power-Via-MDI TLV will not be sent.
Example:
Port 19 enables the function for sending LLDP-MED Extended Power-Via-MDI TLV.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv extendPoe
14.9 lldp transmit med tlv inventory
Command:
lldp transmit med tlv inventory
no lldp transmit med tlv inventory
Function:
Configure the specified port to send LLDP-MED Inventory Management TLVs aggregation, TLVs aggregation
includes 7 TLVs, they are Hardware Revision TLV, Firmware Revision TLV, Software Revision TLV, Serial Number
TLV, Manufacturer Name TLV, Model Name TLV, Asset ID TLV. The no command disables the capability.
Parameter:
None.
Default:
The function is disabled for sending LLDP-MED Inventory Management TLVs.
Command Mode:
Port mode
Usage Guide: