PLANET WGSW-52040 - Manual (Page 592)

36-132
36.1.16 ipv6 mld snooping vlan suppression-query-time
Command:
ipv6 mld snooping vlan <vlan-id> suppression-query-time <value>
no ipv6 mld snooping vlan <vlan-id> suppression-query-time
Function:
Configure the suppression query time; the “no” form of this command restores the default value.
Parameter:
vlan-id: VLAN ID, valid range: <1-4094>
value: valid range: <1-65535>secs.
Command Mode:
Global Mode
Default:
255s
Usage Guide:
This command can only be configured on L2 general querier. The Suppression-query-time represents the period the
suppression state maintains when general querier receives queries from layer 3 MLD within the segment. To use this
command, the query-intervals in different switches within the same segment must be in accordance. It is
recommended to use the default value.
Example:
Switch(config)#ipv6 mld snooping vlan 2 suppression-query-time 270
36.1.17 show ipv6 mld snooping
Command:
show ipv6 mld snooping [vlan <vlan-id>]
Parameter:
<vlan-id> is the number of VLAN specified to display the MLD Snooping messages
Command Mode: