PLANET WGSW-52040 - Manual (Page 179)

8-178
lldp disable
Function:
Enable the LLDP function module of ports in port configuration mode; disable command will disable the LLDP
function module of port.
Parameters:
None.
Default:
the LLDP function module of ports is enabled by default in port configuration mode.
Command Mode:
Port Configuration Mode.
Usage Guide:
When LLDP is globally enabled, it will be enabled on every port, the switch on a port is used to disable this function
when it is unnecessary on the port.
Example:
Disable LLDP function of port on the port ethernet 1/5 of the switch.
Switch(config)#in ethernet 1/5
Switch(Config-If-Ethernet1/5)#lldp disable
8.6 lldp mode
Command:
lldp mode <send | receive | both | disable>
Function:
Configure the operating state of LLDP function of the port.
Parameters:
send: Configure the LLDP function as only being able to send messages.
receive: Configure the LLDP function as only being able to receive messages.
both: Configure the LLDP function as being able to both send and receive messages.
disable: Configure the LLDP function as not being able to send or receive messages.