11 network policy, Network policy – PLANET WGSW-52040 User Manual
Page 246
14-15
14.11 network policy
Command:
network policy {voice | voice-signaling | guest-voice | guest-voice-signaling | softphone-voice |
video-conferencing | streaming-video | video-signaling} [status {enable | disable}] [tag {tagged | untagged}]
[vid {
no network policy {voice | voice-signaling | guest-voice | guest-voice-signaling | softphone-voice |
video-conferencing | streaming- video | video-signaling}
Function:
Configure the network policy of the port, including VLAN ID, the supported application (such as voice and video), the
application priority and the used policy, and so on.
Parameters:
voice, voice-signaling, guest-voice, guest-voice-signaling, softphone-voice, video-conferencing, streaming-video and
video-signaling: the application types are supported by the port.
status: Whether the network policy is usable.
enable: Network Policy of the specified application type has been defined, enable is the default value of the network
policy.
disable: Network Policy of the specified application type is unknown, the fields (such as VLAN ID, L2 priority and
DSCP) are ignored, network connection device will not send TLV of the specified application type.
tag: Configure the specified application to uses tagged or untagged VLAN method.
tagged: Configure the flow of the specified application to use the tagged vlan method, here, the fields (such as VLAN
ID, Layer2 priority and DSCP value) are take effect.
untagged: Configure the flow without tag for the specified application, the fields (such as VLAN ID, Layer2 priority)
are ignored, only DSCP value field takes effect. Untagged is the default value of VLAN method.
vid: Configure VLAN ID that the specified application belongs to. When the peer sends the flow of the specified
application, it will tag the notified VLAN ID, or else the vlan-id value is 1.
vlan-id: Configure the value of VLAN ID, its range from 1 to 4094.
dot1p: Configure the specified application to tag the flow by using 802.1p priority, at the same time, use vlan 0 to load
the flow.
cos: Configure the priority of Ethernet frame for VLAN.
cos-value: Configure the value of Ethernet frame priority for VLAN, its range from 0 to 7, the default value is 5.
dscp: Configure DSCP of VLAN.
dscp-value: DSCP value input by the user, its range from 0 to 63, the default value is 46.
Default:
No network policy is configured on the port.
Command Mode: