PLANET WGSW-52040 - Manual (Page 646)

39-186
Global Mode.
Default:
The default value is 30 seconds.
Usage Guide:
Default value is recommended.
Example:
Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(config)#dot1x timeout tx-period 1200
39.27 dot1x unicast enable
Command:
dot1x unicast enable
no dot1x unicast enable
Function:
Enable the 802.1x unicast passthrough function of switch; the no operation of this command will disable this function.
Command mode:
Global Configuration Mode.
Default:
The 802.1x unicast passthrough function is not enabled in global mode.
Usage Guide:
The 802.1x unicast passthrough authentication for the switch must be enabled first to enable the 802.1x unicast
passthrough function, then the 802.1x function is configured.
Example:
Enabling the 802.1x unicast passthrough function of the switch and enable the 802.1x for port 1/1.
Switch(config)#dot1x enable
Switch(config)# dot1x unicast enable
Switch(config)#interface ethernet1/1
Switch(Config-If-Ethernet1/1)#dot1x enable