PLANET WGSW-52040 - Manual (Page 445)

28-56
dynamically so that those addresses can be used by the administrator for other purposes.
Example:
Reserving addresses from 10.1.128.1 to 10.1.128.10 from dynamic assignment.
Switch(config)#ip dhcp excluded-address 10.1.128.1 10.1.128.10
28.1.17 ip dhcp pool
Command:
ip dhcp pool
no ip dhcp pool
Function:
Configures a DHCP address pool and enter the pool mode; the “no ip dhcp pool “command deletes the
specified address pool.
Parameters:
is the address pool name, up to 32 characters are allowed.
Command mode:
Global Mode
Usage Guide:
This command is used to configure a DHCP address pool under Global Mode and enter the DHCP address
configuration mode.
Example:
Defining an address pool named “1”.
Switch(config)#ip dhcp pool 1
Switch(dhcp-1-config)#
28.1.18 ip dhcp conflict ping-detection enable
Command:
ip dhcp conflict ping-detection enable