PLANET WGSW-52040 - Manual (Page 107)

1-106
superuser:
Switch#copy nos.img ftp://Switch:[email protected]/nos.img
(2) Obtain system file nos.img from the FTP server 10.1.1.1, the username is Switch, password is superuser
Switch#copy ftp://Switch:[email protected]/nos.img nos.img
(3) Save images in the FLASH to the FTP server of 2004:1:2:3::6
Switch#copy nos.img ftp://username:password@2004:1:2:3::6/ nos.img
(4) Obtain system file nos.img from the FTP server 2004:1:2:3::6
Switch#copy ftp:// username:password@2004:1:2:3::6/nos.img nos.img
(5) Save the running configuration files
Switch#copy running-config startup-config
Relevant Command: write
1.5.2 copy（TFTP）
Command:
copy [ascii | binary]
Function:
Download files to the TFTP client.
Parameter:
is the location of the source files or directories to be copied; is the destination
address to which the files or directories to be copied; forms of and vary depending
on different locations of the files or directories. ascii indicates the ASCII standard will be adopted; binary indicates
that the binary system will be adopted in the file transmission（default transmission method）.When URL represents
a TFTP address, its form should be: tftp://{||}/, amongst
| is the IPv4 or IPv6 address of the TFTP server/client, is the name of the
host mapping with the IPv6 address, it does not support the file download and upload with hosts mapping with IPv4
addresses, is the name of the TFTP upload/download file.
Special keyword of the filename
Keywords Source or destination addresses
running-config Running configuration files