PLANET WGSW-52040 - Manual (Page 658)

40-198
Function:
Display the number of dynamic ND of corresponding port and VLAN.
Parameters:
<vlan-id> is play the specified vlan ID. is the name of layer-2 port.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Use this command to display the number of dynamic ND of corresponding port and VLAN.
Examples:
Display the number of dynamic ND of the port and VLAN which are configured with number limitation function of ND.
Switch(config)# show nd-dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show nd-dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
40.13 switchport arp dynamic maximum
Command:
switchport arp dynamic maximum
no switchport arp dynamic maximum
Function:
Set the max number of dynamic ARP allowed by the port, and, at the same time, enable the number limitation
function of dynamic ARP on the port; “no switchport arp dynamic maximum” command is used to disable the
number limitation function of dynamic ARP on the port.
Parameters:
<value> upper limit of the number of dynamic ARP of the port, ranging from 1 to 4096.