PLANET WGSW-52040 - Manual (Page 252)

15-21
Function:
Configure the specified port to forward stp packets across the tunnel, the no command cancels the operation.
Parameter:
None.
Command Mode:
Port mode
Default:
Port does not forward any protocol packets across the tunnel.
Usage Guide:
Disable stp function on the port before configuring this command.
Example:
Configure Ethernet 4/5 to forward stp packets across the tunnel.
Switch(Config)#in Ethernet 4/5
Switch(Config-if-ethernet 4/5)#bpdu-tunnel stp
15.3 bpdu-tunnel gvrp
Command:
bpdu-tunnel gvrp
no bpdu-tunnel gvrp
Function:
Configure the specified port to forward gvrp packets across the tunnel, the no command cancels the operation.
Parameter:
None.
Command Mode:
Port mode
Default: