PLANET WGSW-52040 - Manual (Page 771)

52-311
Specify secondary of MRPP ring.
Parameter:
is the ID of MRPP ring; range is <1-4096>.
Command Mode:
Port mode
Default:
None
Usage Guide:
The command specifies secondary port of MRPP ring. The primary node uses secondary port to receive Hello
packet from primary node. There are no difference on function between primary port and secondary of secondary
node.
The mrpp enable command must be enabled before the control-vlan command be used. If primary port, secondary
port, node-mode and enable commands all be configured after control-vlan, then the mrpp-ring function is enabled.
Example:
Configure secondary port of MRPP ring to 1/3.
Switch(config)#interface ethernet1/3
Switch(Config-If-Ethernet1/3)#mrpp ring 4000 secondary-port
52.15 node-mode
Command:
node-mode {maser | transit}
Function:
Configure the type of the node to primary node or secondary node.
Parameter:
None.
Command Mode:
MRPP ring mode.