PLANET WGSW-52040 - Manual (Page 301)

17-70
17.3.13 switchport mac-vlan enable
Command:
switchport mac-vlan enable
no switchport mac-vlan enable
Function:
Enable the MAC-based VLAN function on the port; the no form of this command will disable the MAC-based VLAN
function on the port.
Parameter:
None.
Command Mode:
Port Mode.
Default:
The MAC-base VLAN function is enabled on the port by default.
Usage Guide:
After adding a MAC address to specified VLAN, the MAC-based VLAN function will be globally enabled. This
command can disable the MAC-based VLAN function on specified port to meet special user applications.
Example:
Disable the MAC-based VLAN function on port1.
Switch#config
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#no switchport mac-vlan enable
17.3.14 switchport subnet-vlan enable
Command:
switchport subnet-vlan enable
no switchport subnet-vlan enable
Function:
Enable the IP-subnet-based VLAN on the port; the no form of this command disables the IP-subnet-based VLAN