15 ipv6 neighbor, 15 ipv6 neighbor -14 – PLANET WGSW-52040 User Manual
Page 403
23-14
Set the time interval of Neighbor Solicitation Message sent by the interface.
Parameter:
parameter <seconds> is the time interval of sending Neighbor Solicitation Message, <seconds> value must be
between 1-3600 seconds, no command restores the default value 1 second.
Command Mode:
Interface Configuration Mode
Default:
The default Request Message time interval is 1 second.
Usage Guide:
The value to be set will include the situation in all routing announcement on the interface. Generally, very short time
interval is not recommended.
Example:
Set Vlan1 interface to send out Neighbor Solicitation Message time interval to be 8 seconds.
Switch(Config-if-Vlan1)#ipv6 nd ns-interval 8
23.2.15 ipv6 neighbor
Command:
ipv6 neighbor
no ipv6 neighbor
Function:
Set static neighbor table entry.
Parameters:
Parameter ipv6-address is static neighbor IPv6 address, parameter hardware-address is static neighbor
hardware address, interface-type is Ethernet type, interface-name is Layer 2 interface name.
Command Mode:
Interface Configuration Mode
Default Situation: