PLANET WGSW-52040 - Manual (Page 259)

17-28
dot1q-tunnel enable
no dot1q-tunnel enable
Function:
Set the access port of the switch to dot1q-tunnel mode; the no command restores to default.
Parameter:
None.
Command Mode:
Port Mode.
Default:
Dot1q-tunnel function disabled on the port by default.
Usage Guide:
After enabling dot1q-tunnel on the port, data packets without VLAN tag (referred to as tag) will be packed with a tag
when entering through the port; those with tag will be packed with an external tag. The TPID in the tag is the global
configuration TPID. it default value is 0x8100, and the VLAN ID is the VLAN ID the port belongs to. Data packets with
double tags will be forwarded according to MAC address and external tag, till the external tag is removed when
transmitted outside from the access port. Since the length of the data packet may be over sized when packed with
external tag, it is recommended to use this command associating the Jumbo function. Normally this command is
used on access ports. This command can not be used when vlan-translation enabled.
Example:
Join port1 into VLAN3, enable dot1q-tunnel function.
Switch(config)#vlan 3
Switch(Config-Vlan3)#switchport interface ethernet 1/1
Switch(Config-Vlan3)#exit
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)# dot1q-tunnel enable
Switch(Config-If-Ethernet1/1)# exit
Switch(config)#
17.1.4 dot1q-tunnel selective enable
Command:
dot1q-tunnel selective enable
no dot1q-tunnel selective enable