PLANET WGSW-52040 - Manual (Page 384)

21-153
21.2 show flow-based-redirect
Command:
show flow-based-redirect {interface [ethernet <IFNAME> | <IFNAME>]}
Function:
Display the information of current flow-based redirection in the system/port.
Parameters:
1. No specified port, display the information of all the flow-based redirection in the system.
2. Specify ports in , display the information of the flow-based redirection configured in the ports listed in
the interface-list.
Command Mode:
Admin Mode and Configuration Mode.
Usage Guide:
This command is used to display the information of current flow-based redirection in the system/port.
Examples:
Switch(config)# show flow-based-redirect
Flow-based-redirect config on interface ethernet 1/1:
RX flow (access-list 1) is redirected to interface Ethernet1/6