PLANET WGSW-52040 User Manual
Page 153
![background image](https://www.manualsdir.com/files/865180/content/doc153.png)
4-152
Parameters:
auto is the auto speed and duplex negotiation, 10 is 10Mbps speed, 100 is 100Mbps speed, 1000 is 1000Mbps
speed, auto is duplex negotiation, full is full-duplex, half is half-duplex; force10-half is the forced 10Mbps at
half-duplex mode; force10-full is the forced 10Mbps at full-duplex mode; force100-half is the forced 100Mbps at
half-duplex mode; force100-full is the forced 100Mbps at full-duplex mode; force100-fx is the forced 100Mbps at
full-duplex mode; module-type is the type of 100Base-FX module; auto-detected: automatic detection;
no-phy-integrated: there is no phy-integratd 100Base-FX module; phy-integrated: phy-integratd 100Base-FX
module; force1g-half is the forced 1000Mbps speed at half-duplex mode; force1g-full is the forced 1000Mbps
speed at full-duplex mode; nonegotiate disables auto-negotiation forcibly for 1000Mb port; master forces the
1000Mb port to be master mode; slave forces the 1000Mb port to be slave mode. force10g-full is the forced
10000Mbps speed at full-duplex mode.
Command mode:
Port Mode.
Default:
Auto-negotiation for speed and duplex mode is set by default.
Usage Guide:
This command is configures the port speed and duplex mode. When configuring port speed and duplex mode, the
speed and duplex mode must be the same as the setting of the remote end, i.e., if the remote device is set to
auto-negotiation, then auto-negotiation should be set at the local port. If the remote end is in forced mode, the same
should be set in the local end.
1000Gb ports are by default master when configuring nonegotiate mode. If one end is set to master mode, the
other end must be set to slave mode.
force1g-half is not supported yet.
Example:
Port 1 of Switch1 is connected to port 1 of Switch2, the following will set both ports in forced 100Mbps at half-duplex
mode.
Switch1(config)#interface ethernet1/1
Switch1(Config-If-Ethernet1/1)#speed-duplex force100-half
Switch2(config)#interface ethernet1/1
Switch2(Config-If-Ethernet1/1)#speed-duplex force100-half