PLANET WGSW-52040 - Manual (Page 399)

23-10
Usage Guide:
Configure the default gateway of the router to specify the default next hop address to which the packets will be sent.
Example:
Specify a default gateway:
Switch(config)# ip default-gateway 10.1.1.10
Cancel the setting of a default gateway:
Switch(config)# no ip default-gateway 10.1.1.10
23.2.10 ip route
Command:
ip route { | /} { | }
[]
no ip route { | >/} [ | ]
[]
Function:
Configure the static route. The no command deletes the static route.
Parameter:
and are respectively destination IP address and subnet mask, shown in dotted decimal notation;
and are respectively the destination IP address and the length of prefix;
is the next-hop IP address shown in dotted decimal notation; is the
next-hop interface; < distance > is the distance value of route management, the range is 1 to 255.
Default:
The default distance value of route management is 1.
Command Mode:
Global Mode.
Usage Guide:
When configuring the next-hop of static route, the next-hop IP address of route packets and the manner of egress or
interface can be appointed.
The distance values of all kinds of the switch routes are the following:
Route Type Distance Value