PLANET WGSW-52040 - Manual (Page 631)

39-171
Function:
Enables the EAP relay authentication function in the switch; the “no dot1x eapor enable” command sets EAP local
end authentication.
Command mode:
Global Mode.
Default:
EAP relay authentication is used by default.
Usage Guide:
The switch and RADIUS may be connected via Ethernet or PPP. If an Ethernet connection exists between the switch
and RADIUS server, the switch needs to authenticate the user by EAP relay (EAPoR authentication); if the switch
connects to the RADIUS server by PPP, the switch will use EAP local end authentication (CHAP authentication). The
switch should use different authentication methods according to the connection between the switch and the
authentication server.
Example:
Setting EAP local end authentication for the switch.
Switch(config)#no dot1x eapor enable
39.7 dot1x enable
Command:
dot1x enable
no dot1x enable
Function:
Enables the 802.1x function in the switch and ports: the "no dot1x enable" command disables the 802.1x function.
Command mode:
Global Mode and Port Mode.
Default:
802.1x function is not enabled in global mode by default; if 802.1x is enabled under Global Mode, 802.1x will not be
enabled for the ports by default.