PLANET WGSW-52040 - Manual (Page 541)

33-81
33.25 ip dhcp snooping limit-rate
Command:
ip dhcp snooping limit-rate <pps>
no ip dhcp snooping limit-rate
Function:
Set the DHCP message rate limit
Parameters:
: The number of DHCP messages transmitted in every minute, ranging from 0 to 100. Its default value is
100. 0 means that no DHCP message will be transmitted.
Command Mode:
Globe mode
Default Settings:
The default value is 100.
Usage Guide:
After enabling DHCP snooping, the switch will monitor all the DHCP messages and implement software transmission.
The software performance of the switch is relative to the type of the switch, its current load and so on.
Example:
Set the message transmission rate as 50pps.
switch(config)#ip dhcp snooping limit-rate 50
33.26 ip dhcp snooping trust
Command:
ip dhcp snooping trust
no ip dhcp snooping trust
Function:
Set or delete the DHCP Snooping trust attributes of a port.
Parameters:
None