PLANET WGSW-52040 - Manual (Page 102)

1-101
1.4.18 snmp-server securityip
Command:
snmp-server securityip {> | >}
no snmp-server securityip {> | >}
Function:
Configure security IPv4 or IPv6 address allowed to access NMS management station; the no command deletes
security IPv4 or IPv6 address configured.
Command Mode:
Global Mode.
Parameter:
is NMS security IPv4 address, dotted decimal notation.
is NMS security IPv6 address, colon hexadecimal.
Usage Guide:
It is only the consistency between NMS administration station IPv4 or IPv6 address and security IPv4 or IPv6
address configured by the command, so it send SNMP packet could be processed by switch, the command only
applies to SNMP. Allows configuration the IPv4 or IPv6 address of the network manage station receiving the SNMP
Trap message, but the IP addresses are less than 20 in all.
Example:
Configure security IP address of NMS management station.
Switch(config)#snmp-server securityip 1.1.1.5
Delete security IPv6 address.
Switch(config)#no snmp-server securityip 2001::1
1.4.19 snmp-server securityip
Command:
snmp-server securityip {enable | disable}
Function:
Enable/disable the security IP address authentication on NMS management station.
Command Mode: