PLANET WGSW-52040 - Manual (Page 304)

17-73
Disable the Voice VLAN function on port3.
Switch#config
Switch(config)#interface ethernet1/3
switch(Config-If-Ethernet1/3)#no switchport voice-vlan enable
17.4.3 voice-vlan
Command:
voice-vlan mac <mac-address> mask <mac-mask> priority <priority-id>[name<voice-name>]
no voice-vlan {mac > mask <mac-mask> | name <voice-name> | all}
Function:
Specify certain voice equipment to join in Voice VLAN; the no form of this command will let the equipment leave the
Voice VLAN.
Parameter:
Mac-address is the voice equipment MAC address, shown in ”xx-xx-xx-xx-xx-xx” format; mac-mask is the last eight
digit of the mask code of the MAC address, the valid values are: 0xff, 0xfe, 0xfc, 0xf8, 0xf0, 0xe0, 0xc0,0x80, 0x0;
priority-id is the priority of the voice traffic, the valid range is 0–7; the voice-name is the name of the voice equipment,
which is to facilitate the equipment management; all indicates all the MAC addresses of the voice equipments.
Command Mode:
Global Mode.
Default:
This command will add a specified voice equipment into the Voice VLAN, if a non VLAN labeled data packet from the
specified voice equipment enters through the switch port, then no matter through which port the packet enters, it will
belongs to Voice VLAN. The command will not interfere with the packets of VLAN labels.
Example:
Add the 256 sets of voice equipments of the R&D department with MAC address ranging from 00-30-4f-11-22-00 to
00-30-4f-11-22-ff to the Voice VLAN.
Switch#config
Switch(config)#voice-vlan vlan 100
Switch(config)#voice-vlan mac 00-30-4f-11-22-00 mask 0 priority 5 name test