PLANET WGSW-52040 - Manual (Page 875)

65-415
Default:
1200pps.
Usage Guide:
The total rate set by the command have an effect on CPU receiving packets, so it is supposed to be used with the
help of the technical support.
Example:
Set the total rate of the CPU receive packets to 1500pps.
Switch(config)#cpu-rx-ratelimit total 1500
65.4 debug driver
Command:
debug driver {receive | send} [interface { | all}] [protocol { | discard | all}]
[detail]
no debug driver {receive | send}
Function:
Turn on the on-off of showing the information of the CPU receiving or sending packets, the “no debug driver
{receive | send}” command turns off the on-off.
Parameter:
receive | send show the information of receiving or sending packets;
interface {| all}: interface-list is the Ethernet port number, all indicate all the Ethernet ports.
protocol { | discard | all}: protocol-type is the type of the protocol of the packet, including snmp,
telnet, http, dhcp, igmp, arp, ssh, icmpv6, dot1x, gvrp, stp, lacp, cluster, eapou all means all of the protocol types,
discard means all the discarded packets. Detail show detail information.
Command Mode:
Admin Mode
Usage Guide:
This command is used to debug, it is supposed to be used with the help of the technical support.
Example: