PLANET WGSW-52040 - Manual (Page 683)

44-223
Default:
No specific source IP address for RADIUS packet is configured, the IP address of the interface from which the
RADIUS packets are sent is used as source IP address of RADIUS packet.
Command mode:
Global Mode.
Usage guide:
The source IP address must belongs to one of the IP interface of the switch, otherwise an failure message of binding
IP address will be returned when the switch send RADIUS packet. We suggest using the IP address of loopback
interface as source IP address, it avoids that the packets from RADIUS server are dropped when the interface
link-down.
Example:
Configure the source ip address of RADIUS packet as 192.168.2.254.
Switch#radius nas-ipv4 192.168.2.254
44.10 radius nas-ipv6
Command:
radius nas-ipv6
no radius nas-ipv6
Function:
Configure the source IPv6 address for RADIUS packet sent by the switch. The no command deletes the
configuration.
Parameter:
is the source IPv6 address of the RADIUS packet, it must be a valid unicast IPv6 address.
Default:
No specific source IPv6 address for RADIUS packet is configured, the IPv6 address of the interface from which the
RADIUS packets are sent is used as source IPv6 address of RADIUS packet.
Command mode:
Global Mode.