PLANET WGSW-52040 - Manual (Page 227)

12-226
Disable.
Command Mode:
Port mode
Usage Guide:
Clear all dynamic MACs after the interface enabled port-security, and all MACs learnt from the interfaces are tagged
with FDB_TYPE_PORT_SECURITY_DYNAMIC. After disabling port-security of the interfaces, clear all secure
MACs or change them into the dynamic MACs.
Example:
Enable port-security on the interface.
Switch(config-if- ethernet1/1)#switchport port-security
12.4 switchport port-security aging
Command:
switchport port-security aging {static | time <value> | type {absolute | inactivity}}
no switchport port-security violation aging {static | time | type}
Function:
Enable the aging entries of port-security, and specify the aging time and type on the interface.
Parameter:
static：Enable the aging of the static MAC address configured on the specified interface.
time <value>：Specify MAC aging time of the interface, its range from 1 to 1440mins. The default value is 0, that
means disable the aging.
type：Specify the aging type
absolute：The expiration of the aging timer on the interface, all secure MACs of the interfaces will get aged and be
removed from the MAC table.
inactivity：The expiration of the aging timer on the interface, the entries will get aged without the traffic, the entries
are still kept in the aging period with the traffic.
Default:
Do not enable port-security aging, the default aging time is 0.
Aging mode is absolute by default.
The static entries are not aged by default.