PLANET WGSW-52040 - Manual (Page 473)

29-13
Function:
This command configures the address pool which will be allocated by the DHCPv6 server through the specified
interface. The no form of this command will remove the address pool configuration.
Parameters:
<poolname> is a string with its length less than 32, which designates the name of the address pool which is
associated with the specified interface. If the rapid-commit option has been specified, the DHCPv6 server send a
REPLY packet to the client immediately after receiving the SOLICIT packet. If the preference option has been
specified, <value> will be the priority of the DHCPv6 server, with its value allowed between 0 and 255, and with 0 by
default, the bigger the preference value is, the higher the priority of the DHCPv6 server. If the allow-hint option has
been specified, the client expected value of parameters will be appended in its request packets.
Command Mode:
Interface Configuration Mode.
Default:
DHCPv6 address pool based on port is not configured by default.
Usage Guide:
This command configure the DHCPv6 address pool which is applied by the DHCPv6 server for the specified
interface, as well as optional parameters. One VLAN can bind many DHCPv6 address pools and assign the address
for DHCPv6 request packet from direct-link and relay delegation.
Example:
Switch(Config-if-Vlan1)#ipv6 dhcp server PoolA preference 80 rapid-commit allow-hint
29.17 ipv6 general-prefix
Command:
ipv6 general-prefix
no ipv6 general-prefix
Function:
To define an IPv6 general prefix. The no form of this command will delete the configuration.
Parameter:
is a character string less than 32 characters, to use as IPv6 general prefix name.