PLANET WGSW-52040 - Manual (Page 214)

11-213
Parameters:
active, active mode
passive, passive mode
Command Mode:
Port mode
Default:
active mode.
Usage Guide:
At least one of the two connected OAM entities should be configured to active mode. Once OAM is enabled, the
working mode of OAM cannot be changed and you need to disable OAM function if you have to change the working
mode.
Example:
Set the mode of OAM function on ethernet 1/4 to passive mode.
Switch(Config-If-Ethernet1/4)#ethernet-oam mode passive
11.21 ethernet-oam period
Command:
ethernet-oam period <seconds>
no ethernet-oam mode
Function:
Configure the transmission period of Information OAMPDU, no command restores the default value.
Parameters:
<seconds>, sending period, ranging from 1 to 2 seconds.
Command Mode:
Port mode
Default:
1s.