PLANET WGSW-52040 - Manual (Page 106)

1-105
Download files to the FTP client.
Parameter:
is the location of the source files or directories to be copied; is the destination
address to which the files or directories to be copied; forms of and vary depending
on different locations of the files or directories. ascii indicates the ASCII standard will be adopted; binary indicates
that the binary system will be adopted in the file transmission（default transmission method）.When URL represents
an FTP address, its form should be:
ftp://:@{|| }/,amongst is the
FTP user name, > is the FTP user password, <ipaddress>|<ipv6address> is the IPv4 or IPv6 address of
the FTP server/client, is the name of the host mapping with the IPv6 address, it does not support the file
download and upload with hosts mapping with IPv4 addresses, is the name of the FTP upload/download
file.
Special keywords of the filename
Keywords Source or destination addresses
running-config Running configuration files
startup-config It means the reboot configuration files when using copy running-config
startup-config command
nos.img System files
boot.rom System startup files
stacking/nos.img As destination address, execute system files upgrade for Slave in stacking
mode
stacking/nos.rom As destination address, execute system startup files upgrade for Slave in
stacking mode
Command Mode:
Admin Mode.
Usage Guide:
This command supports command line hints, namely if the user can enter commands in following forms: copy
ftp:// or copy ftp:// and press Enter, following hints will be provided by the system：
ftp server ip/ipv6 address [x.x.x.x]/[x:x::x:x] >
ftp username>
ftp password>
ftp filename>
Requesting for FTP server address, user name, password and file name
Examples:
(1) Save images in the FLASH to the FTP server of 10.1.1.1, FTP server username is Switch, password is