PLANET WGSW-52040 - Manual (Page 586)

36-126
36.1.8 ipv6 mld snooping vlan limit
Command:
ipv6 mld snooping vlan < vlan-id > limit {group <g_limit> | source <s_limit>}
no ipv6 mld snooping vlan < vlan-id > limit
Function:
Configure number of groups the MLD snooping can join and the maximum number of sources in each group.
Parameter:
vlan-id: VLAN ID, the valid range is <1-4094>
g_limit: <1-65535>, max number of groups joined
s_limit: <1-65535>, max number of source entries in each group, consisting of include source and exclude source
Command Mode:
Global Mode
Default:
Maximum 50 groups by default, with each group capable with 40 source entries.
Usage Guide:
When number of joined group reaches the limit, new group requesting for joining in will be rejected for preventing
hostile attacks. To use this command, MLD snooping must be enabled on VLAN. The “no” form of this command
restores the default other than set to “no limit”. For the safety considerations, this command will not be configured to
“no limit”. It is recommended to use default value and if layer 3 MLD is in operation, please make this configuration in
accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 limit group 300
36.1.9 ipv6 mld snooping vlan mrouter-port interface
Command:
ipv6 mld snooping vlan <vlan-id> mrouter-port interface [<ethernet>|<port-channel>] <ifname>
no ipv6 mld snooping vlan <vlan-id> mrouter-port interface [<ethernet>|<port-channel>] <ifname>
Function: