PLANET WGSW-52040 - Manual (Page 792)

53-332
By default, disable receiving the flush packets of updating MAC address.
Command mode:
Port mode.
Usage Guide:
Enable receiving the flush packets of updating MAC address table.
Example:
Enable receiving the flush packets of updating the MAC address.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush enable mac
53.26 ulpp flush enable mac-vlan
Command:
ulpp flush enable mac-vlan
Function:
Enable receiving the flush packets of mac-vlan type.
Parameter:
None.
Default:
Disable.
Command mode:
Port mode.
Usage Guide:
If enabling this function, configure the interface to receive the flush packets handled mac-vlan type and delete the
dynamic unicast mac according to vlan information in the packets.
Example:
Enable receiving the flush packets deleted by mac-vlan of port.
Switch(config)#interface e1/2