PLANET WGSW-52040 - Manual (Page 639)

39-179
39.17 dot1x portbased mode single-mode
Command:
dot1x portbased mode single-mode
no dot1x portbased mode single-mode
Function:
Set the single-mode based on portbase authentication mode; the no command disables this function.
Parameters:
None.
Command mode:
Port Mode
Default:
Disable the single-mode.
Usage Guide:
This command takes effect when the access mode of the port is set as portbase only. Before configuring the
single-mode, if the port has enabled dot1x port-method portbased command and exist online users, the switch will
enforce all users of this port are offline. After that, this port only allows a user to pass the authentication, the user can
access the specified network resource, but other authentication users of this port will be denied and cannot access
the network. After disabling the single-mode, the switch also enforce the authenticated user is offline.
Example:
Switch(Config-If-Ethernet1/1)#dot1x portbased mode single-mode
39.18 dot1x port-control
Command:
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
Function:
Sets the 802.1x authentication status; the “no dot1x port-control” command restores the default setting.
Parameters: