PLANET WGSW-52040 - Manual (Page 584)

36-124
To configure MLD snooping on certain VLAN, the global MLD snooping should be first enabled. Disable MLD
snooping on specified VLAN with the no ipv6 mld snooping vlan vid command
Example:
Enable MLD snooping on VLAN 100 under global mode.
Switch (config)#ipv6 mld snooping vlan 100
36.1.6 ipv6 mld snooping vlan immediate-leave
Command:
ipv6 mld snooping vlan immediate-leave
no ipv6 mld snooping vlan immediate-leave
Function:
Enable immediate-leave function of the MLD protocol in specified VLAN; the “no” form of this command disables the
immediate-leave function of the MLD protocol
Parameter:
is the id number of specified VLAN, with valid range of <1-4094>.
Command Mode:
Global Mode
Default:
Disabled by default
Usage Guide:
Enabling the immediate-leave function of the MLD protocol will hasten the process the port leaves one multicast
group, in which the specified group query of the group will not be sent and the port will be directly deleted.
Example:
Enable the MLD immediate-leave function on VLAN 100.
Switch (config)#ipv6 mld snooping vlan 100 immediate-leave