PLANET WGSW-52040 - Manual (Page 122)

3-121
Chapter 3 Commands for Cluster
3.1 clear cluster nodes
Command:
clear cluster nodes [nodes-sn | mac-address ]
Function:
Clear the nodes in the candidate list found by the commander switch.
Parameters:
candidate-sn-list: sn of candidate switches, ranging from 1 to 256. More than one candidate can be specified.
mac-address: mac address of the switches (including all candidates, members and other switches).
Default:
No parameter means to clear information of all switches.
Command Mode:
Admin Mode.
Usage Guide:
After executing this command, the information of this node will be deleted from the chain list saved on commander
switch. In 30 seconds, the commander will recreate a cluster topology and re-add this node. But after being read, the
candidate id of the switch might change. The command can only be executed on commander switches
Example:
Clear all candidate switch lists found by the commander switch.
Switch#clear cluster nodes
3.2 cluster auto-add
Command:
cluster auto-add
no cluster auto-add
Function:
When this command is executed in the commander switch, the newly discovered candidate switches will be added to