PLANET WGSW-52040 - Manual (Page 686)

44-226
Command mode:
Global Mode
Default:
No RADIUS authentication server is configured by default.
Usage Guide:
This command is used to specify the IPv4 address or IPv6 address and port number, cipher key string and access
mode of the specified RADIUS server for switch authentication, multiple command instances can be configured. The
port parameter is used to specify authentication port number, which must be the same as the specified authentication
port in the RADIUS server, the default port number is 1812. If this port number is set to 0, the specified server is
regard as non-authenticating. This command can be used repeatedly to configure multiple RADIUS servers
communicating with the switch, the configured order is used as the priority for the switch authentication server. When
the first server has responded (whether the authentication is successed or failed), switch does not send the
authentication request to the next. If primary is specified, then the specified RADIUS server will be the primary
server. It will use the cipher key which be configured by radius-server key global command if the current
RADIUS server not configure key. Besides, it can designate the current RADIUS server only use 802.1x
authentication or telnet authentication via access-mode option. It is not configure access-mode option and all
services can use current RADIUS server by default.
Example:
Setting the RADIUS authentication server address as 2004:1:2:3::2.
Switch(config)#radius-server authentication host 2004:1:2:3::2
44.13 radius-server dead-time
Command:
radius-server dead-time <minutes>
no radius-server dead-time
Function:
Configures the restore time when RADIUS server is down; the “no radius-server dead-time” command restores the
default setting.
Parameters:
is the down -restore time for RADIUS server in minutes, the valid range is 1 to 255.
Command mode:
Global Mode