PLANET WGSW-52040 - Manual (Page 576)

35-116
35.2.19 ip igmp snooping vlan report source-address
Command:
ip igmp snooping vlan report source-address
no ip igmp snooping vlan report source-address
Function:
Configure forward report source-address for IGMP, the “no ip igmp snooping vlan report
source-address” command restores the default setting.
Parameter:
vlan-id: VLAN ID range<1-4094>;
A.B.C.D: IP address, can be 0.0.0.0.
Command Mode:
Global Mode.
Default:
Disabled.
Usage Guide:
Default configuration is recommended here. If IGMP snooping needs to be configured, the source address for
forwarded IGMP messages can be 0.0.0.0. If it is required by the upstream that IGMP messages should use the
same network address, the source address of IGMP messages should be configured to be the same with upstream.
Example:
Switch (config)#ip igmp snooping vlan 2 report source-address 10.1.1.1
35.2.20 ip igmp snooping vlan specific-query-mrsp
Command:
ip igmp snooping vlan specific-query-mrsp
no ip igmp snooping vlan specific-query-mrspt
Function: