PLANET WGSW-52040 - Manual (Page 346)

19-115
sets port priority. The valid range is from 0 to 240. The value should be the multiples of 16, such as 0,
16, 32, 48…240.
Command mode:
Port Mode
Default:
The default port priority is 32768.
Usage Guide:
By setting the port priority to designated port. The lower the value of the port priority is, the higher the priority is.
Example:
Set the port priority as 4096 on the port 1.
Switch(Config-If-Ethernet1/1)#spanning-tree port-priority 4096
19.1.29 spanning-tree priority
Command:
spanning-tree priority
no spanning-tree priority
Function:
Configure the spanning-tree priority; the “no spanning-tree priority” command restores the default priority.
Parameter:
is the priority of the bridging switch. Its value should be round times of 4096 between 0 and 61440,
such as 0, 4096, 8192… 61440.
Command Mode:
Global Mode.
Default:
Priority is 32768.
Usage Guide:
The bridge ID can be altered by changing the priority of the switch. Further, the priority information can also be used